Brittle coating technique is used for_________________?

A. determining brittleness
B. protecting metal against corrosion
C. protecting metal against wear and tear
D. experimental stress analysis
E. non-destructive testing of metals

Related Mcqs:

Eye bolts are used for_________________?
A. foundation purposes B. locking devices * C. absorbing shock and vibrations D. transmission of power E. lifting and transportation of machines and cubicles...
The edges of the plates for cylindrical vessels are usually bevelled to an angle of 80° for_________________?
A. reducing stress concentration B. ease of manufacture C. safety D. fullering and caulking E. all of the above...
If an unsupported uniform cross sectional elastic bar is subjected to a longitudinal impact from a rigid bob moving with velocity v, then a compressive wave of intensity sc is propagated through the bar as follows______________________?
A. vpE B. vVvF C. WpE/2 D. IvHpE E. none of the above, where E = modulus of elasticity and p = mass density...
Stress concentration is caused due to_____________________?
A. variation in properties of material from point to point in a member B. pitting at’points or areas at which loads on a member are applied C. abrupt change of section D. all of the above E. none of the above...
In nitrated parts, the origins of the fatigue cracks will occur at__________________?
A. surface B. just below the surface C. within the core D. could occur anywhere E. none of the above...
For applications involving high stresses in one direction only the following type of thread would be best suited______________________?
A. ISO metric thread B. acme thread C. square thread D. buttress thread E. British Association thread...
A key made from a cylindrical disc having segmental cross-section, is known as______________?
A. wood-ruff key B. feather key C. flat saddle key D. gib head key E. hollow saddle key...
If two springs are in parallel then their overall stiffness will be_______________?
A. half B. same C. double D. unpredictable E. none of the above...
If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
A. square B. acme C. buttress D. BSW E. metric...
The piston rod of a steam engine is usually connected to the cross head by means of__________________?
A. bolted joint B. kunckle joint C. cotter joint D. universal joint E. universal coupling...